I want to put my Drive-shaft safety loop in on Tuesday. Is anybody available to help? Or can somebody at-least tell me how to do it.
-
Hello there guest and welcome to our forum!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
Drive-Shaft Safety Loop Install Help
- Thread starter IgottaV8
- Start date
which one did you get? Most of them bolt right up to your seat brackets.
sdsubzero4
Spring Valley, CA
Had to drill a few holes for the bolts when Todd installed mine.
yeah that is why it is important to know what brand it is. Most come with instructions and are held in by 4 bolts.
sdsubzero4
Spring Valley, CA
Ethan: Check out this link. http://www.wickedstangs.com/forum/showthread.php?t=7173
I got the FRPP 3.5" DS Loop
I got the FRPP 3.5" DS Loop
I have the Lakewood Driveshaft Safety Loop. It says that I need to drill holes in my Floorboard.
sdsubzero4
Spring Valley, CA
Yep, just like mine.
Cool so i should be able to get it done in a day, right?
sdsubzero4
Spring Valley, CA
Oh yeah. Probably 2-3 hours.
Sweet, so it will probably take me 5-6 hours, so I will be sure to get started early.
Tommy
New Member
Ethan, thats the same one I installed in the race car the day we did the gears, and same one my notch will have tomorrow. You have to drill 8 holes (4 on each side) from underneath the floorboards, and remove the door sill plate to lift the carpet. Once the carpet is lifted you will probably need someone to help hold the nut/bolt from the opposite side.
Just make sure to carefully mark the drill locations.