M
Mustangcwo
Guest
Picked this up last week and will be installing in September. Time to put those ET Streets to the test. Vortech V3 48L Sci HO.
-
Hello there guest and welcome to our forum!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
Token A4
Well-Known Member
did it come with the doritos?? if so imma need 2 haha
Lordgufi
Well-Known Member
i dont like doritos =(
Tommy
New Member
Dang it MustangCWO! quit teasing! I already over spent on my build, now this makes me want to get more in debt!!
sweet now you can run a 9.0 at the next MVTW III :rofl:
Maverick
Well-Known Member
Very nice !!! Hope your car is doing ok - holler if you still need help with that rear seal.
Yup Same here I'm always up to work onyour car.
That sure is perty..... Install it before the MVTW!!!!!!!
sdsubzero4
Spring Valley, CA
I like!!!!!
Tommy
New Member
I'll take the Doritos and my dog Max will take the beggin strips please
atlblue98gt
Greer, SC
Shinny. I like
If you don't put out some crazy numbers with that thing, we might be pretty close in ET's when I get my engine all done and some struts and shocks put in. It should be fun.
Red
Well-Known Member
I'd like to know too.
looks like a snail to me....
Xodus989
Well-Known Member
50PSI! :rofl:
Man! I want one of those!!! *starts saving up*
Man! I want one of those!!! *starts saving up*
A lil off target but hey Ethan my friend Josh is gunning for you when we get back. He is installing a fuel system, bigger turbo, built trans, and a few other mods.... He should be around 1500 ftlbs of torque lol.
02gt
Well-Known Member
I'll trade you head units...
M
Mustangcwo
Guest
Alright, now that you had all your fun and games...here is the target:
375RWHP at 10psi. Head unit is good to 22psi, so I wont need to upgrade anything but pullies for quite some time. Of course, the 331 build will have to be complete before I put the 15psi pulley on :rock:.
Here is the progress so far:
T=Rex pump installed and operational
MSD ignition located under the driver seat and tested good
5143 autolite plugs gapped to .030 installed
Double crank pulley installed
Alternator and smog pulley relocated
That crank pulley has two belt channels??? and the alternator is on the bottom???
Look at all the new shinny stuff!!!!
375RWHP at 10psi. Head unit is good to 22psi, so I wont need to upgrade anything but pullies for quite some time. Of course, the 331 build will have to be complete before I put the 15psi pulley on :rock:.
Here is the progress so far:
T=Rex pump installed and operational
MSD ignition located under the driver seat and tested good
5143 autolite plugs gapped to .030 installed
Double crank pulley installed
Alternator and smog pulley relocated
That crank pulley has two belt channels??? and the alternator is on the bottom???
Look at all the new shinny stuff!!!!