...hood stripe x dos...

[Ichiduo]

okay, how much would it cost for you to do this type of stripe:

it's sorta like the stock mach 1 hood stripe, but as you can see, it has its subtle differences.

comparison follows:

stock:

one i want:

scroll up you lazy bishes... :lol:

thanks :D

 

[Feared]

i like it!

 

[GT400SC]

I don't know who you're asking but if it's me...

Price depends on a couple of things.

What is the WIDEST dimension (outside to outside)?

Is this going on a hood with ram air or a flat hood? Is this for you?

The material doesn't cost all that much, it's trying to duplicate the exact dimensions, curves, arcs and the opening for the scoop.

 

[Ichiduo]

i was trying to measure it out, but the mach hoods bow, so i got a measurement of 21 1/2 inches at the widest part of the cowl (part closest to the windshield), and 13 1/2 inches at the smallest part (towards the grille where the stripe should end in the front). the total length i want for the stripe is 45 inches. hope that helps out.

 

[Ichiduo]

and yes, it's going on my hood. just like the mach in the pic.

 

[Ichiduo]

i like it!

thanks dustin. what i like about it is it's subtle. if you look at that stripe next to the stock hood stripe, it might not stick out that much, but once you notice... it makes a nice change.

 

[GT400SC]

I can't cut it, max width for my machine is 15"-- Sorry!

 

[Ichiduo]

I can't cut it, max width for my machine is 15"-- Sorry!

s'okay gt... you tried. wanted to see if you could do it first before i tried someone else.