96 mystic cobra for sale

[vanqsh_dsg04]

i need to sell my 96 mystic cobra asap it has alot of work done to it but today i think i spun a bearing alot of the parts on it the heads have a stage 2 port and polish 550 lift cams 5 angle valvy job eagle rods je pistons 4.10's sorty shifter jba titanium shorty headers cated bassani x pipe magnaflow cat back accufab throttle body eibach springs tokico shocks bigger eibach read sway bar the car has 72k mi i need to get $5,000 out of it or as close as u can get to 5k any other questions dont be afraid to ask


Thanks,
Chance

 

[yosemiddysam]

What makes you think you spun a Rod ??????

 

[vanqsh_dsg04]

its knockin bad and it wont run very well

 

[IgottaV8]

Maybe you just blew a piston ring or something

 

[vanqsh_dsg04]

either way i dnt think i have the money to fix it i gotta sell it and fast cuz i leave on may 1st and everyone ask around for me see if anyone is looking for a sweet little project car

 

[blackstallion06]

I maybe intrested send me a pm with your number.

 

[Foxman]

normally a spun rod doesnt effect the way the car runs, just makes noise... are you sure its not just the timing chain??? that would make more sense and is a cheap fix....

A lot of people mistake a stretched or broken timing chain for spun rods bearings

and that would make it run like its on only 4 cylinders

 

[vanqsh_dsg04]

honestly idk what it is im just going off what everyone is telling me

 

[Foxman]

I would check the timing chain... will bet money thats what it is.... when they go it sounds just like a rod knock... also if a coil pack went out.... it will sound the same

 

[Foxman]

good luck getting 5k for a broken car...

 

[vanqsh_dsg04]

well its worth a shot i dnt have much choice i mean there are ALOT of goodies on the car that should still be good so i mean i if sumone has another 4.6 short block then the heads and everything is still good and they have a stage 2 port job and the cams are hp stage 2 cams so like i said there is alot of good **** on the car

 

[orange395w]

normally a spun rod doesnt effect the way the car runs, just makes noise... are you sure its not just the timing chain??? that would make more sense and is a cheap fix....

A lot of people mistake a stretched or broken timing chain for spun rods bearings

and that would make it run like its on only 4 cylinders

He stated in the chat box that he had to add 4qts of oil. I don't think it's the timing chain. I hate to say this, but the parts that you are mentioning to be worth all of the money have the possibility of being damaged, so keep that in mind.

 

[vanqsh_dsg04]

well i was just saying what is all in the car but the heads and cams should still be good right?

 

[yosemiddysam]

Not if you broke a rod or dropped a valve........ It all just depends on the cranage when you tear into the motor.

 

[vanqsh_dsg04]

i doubt i broke a rod i dnt think i did anything bad enough to break an eagle rod but who knows with my ****ty luck

 

[Foxman]

4 qt how long did you drive it... and a broke timing chain can make oil disappear as well... valves staying open....

4qt is a lot!

 

[vanqsh_dsg04]

i dnt know how long i drove it... it cut off and i added oil ran it for like 45 secs and i cut it off i dnt know where the oil whent i dnt know of any leaks and it doesnt smell or look like it burnt it. but we put 4 qts in it may have only needed 3 idr my friend said 4 i thought it was 3 either way thats alot

 

[vanqsh_dsg04]

if anybody wants the car if u can take over payments i owe $8k on it and i will pay you $3k maybe a little more for the repairs i just need to get this car off my hands asap! i dont have the time to work on it. if u have any questions plz, plz dnt be afraid to ask.

 

[Foxman]

check your coolant... snapped timing chain blown head gasket.......

 

[vanqsh_dsg04]

coolants good the head gasket is fine and the car will crank up so i dnt think the timing chain is snaped