• Hello there guest and welcome to our forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

putting together a 460

Tommy

Tommy

New Member
Putting together a 460 ****FIRED IT UP!!! *****

check out the 460 I'm finishing up for a 351/400m swap....

DSC01614.jpg



DSC01615.jpg


DSC01617.jpg


DSC01618.jpg
 
Tommy

Tommy

New Member
02gt said:
Holy crap, that is some cubes. How much power is rated at?
Click to expand...



It's estimated at about low 500's on pump gas. It was built mainly for torque. The guy that built it said he put bigger valves, a cam (don't know specs) and shoule be good for about +/- 600 lb ft of low end torque.

Not sure what he used to build it or specs on hardware, but I'm adding a 750 Four Barrell Holley Carb, MSD ignition and removing the stock exhaust manifolds to slap on hooker headers. No cats, Flowmaster mufflers and I'm getting the stock c6 tranny refreshed. It already has 4:11 gears, but not sure if I should go with 3:73's for highway travel. I still have time to decide that.

No doubt it's gonna be a haulin' beast!
 
Foxman

Foxman

Well-Known Member
i would say keep the 4:11's a go with a AOD!!! with the big tirwes you might not need the od but it wont be any more expensive to just get a OD!
 
Foxman

Foxman

Well-Known Member
that C6 is goingt to be around a grand to pay someone to build it for a 600 ft. of torque big block!
 
Tommy

Tommy

New Member
Machman said:
that C6 is goingt to be around a grand to pay someone to build it for a 600 ft. of torque big block!
Click to expand...


I got quoted $1,300. The guy said it can withstand tremendous torque and off road abuse. Tires are being swapped to 37's from those 35's too, so I'll leave the 4:11's.
 
You must log in or register to reply here.
Top