• Hello there guest and welcome to our forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

Torn Rear Lower Control Arm Bushings

Mustangcwo

Crew Chief
Staff member
Board Member
Since I started stepping up to the plate and pushing the car, I have found some new problems.

While I was welding the upper control arm boxes, I noticed the lower control arm bushings were tearing at the edges. I decided to drop both control arms for further investigation. I appears that the bushings provided by UPR are not up to race standards:

004.jpg


005-1.jpg


So I ordered a new set of energy suspension bushings, however they were not sized for my aftermarket lower control arms. To correct this problem, I had my talented machinist turn them to .020 over and then hammered them home.

003-1.jpg


002-1.jpg


001-2.jpg


I also had them turn an additional set of bushings made from a lubricated hardened plastic; just in case.

006-1.jpg


007-1.jpg


I will see how the car reacts on Saturday and make the bushing change if needed. I prefer the more comfortable ride, but I must make the BEAST performance ready.
 
Top