1. Hello there guest and welcome to our forum!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!
    Dismiss Notice

Rear end straightening / narrowing

orange395w Jun 23, 2013

  1. orange395w

    orange395w OG MEMBER Donator San Diego Chapter

    Messages:
    3,152
    Likes Received:
    168
    Trophy Points:
    278
    Automobile:
    2013 Mustang
    I've had 2 people in the last week ask me about welding up axle tubes. I just wanted to let everyone know that I have been thinking about this for a while now and with the push of a few people decided to make a fixture and buy the tools to straighten, narrow and weld axle tubes.

    The fixture tooling is almost complete and I have the rear end alignment bar kit. I will let you guys know when it is ready.

    [​IMG]
     
    wickedstangs likes this.
  2. tkeinia

    tkeinia Well-Known Member Donator

    Messages:
    458
    Likes Received:
    149
    Trophy Points:
    258
    i was just thinking of doing this on my car.
     
  3. orange395w

    orange395w OG MEMBER Donator San Diego Chapter

    Messages:
    3,152
    Likes Received:
    168
    Trophy Points:
    278
    Automobile:
    2013 Mustang
    Texas is too far for me :)
     
  4. tkeinia

    tkeinia Well-Known Member Donator

    Messages:
    458
    Likes Received:
    149
    Trophy Points:
    258
    if only i was back in san diego.
     
    wickedstangs likes this.
  5. wickedstangs

    wickedstangs Chula Vista, CA Staff Member Administrator San Diego Chapter

    Messages:
    15,486
    Likes Received:
    963
    Trophy Points:
    408
    Very nice.. Keep up the good work and awesome customer service.. My car is ready for round two... Turbo install.
     
    orange395w likes this.
  6. orange395w

    orange395w OG MEMBER Donator San Diego Chapter

    Messages:
    3,152
    Likes Received:
    168
    Trophy Points:
    278
    Automobile:
    2013 Mustang
    I have a couple more things to do like trim the all thread and make a couple clamps for the top part, but you guys get the idea. It's just about finished.

    [​IMG]

    [​IMG]
     
  7. wickedstangs

    wickedstangs Chula Vista, CA Staff Member Administrator San Diego Chapter

    Messages:
    15,486
    Likes Received:
    963
    Trophy Points:
    408
    looks good...
     

Share This Page