Due to the high temps the car is running, I decided to open the front end and allow more cooling over the top of the engine.
Here are some pictures before I started:
Here are some pictures before I started:
-
Hello there guest and welcome to our forum!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
Install Cobra Bumper Insert 87-93 Mustang
- Thread starter Mustangcwo
- Start date
Next, I downloaded this template, cut out the pieces and then taped them to the car. Once I had the paper in position, I took a sharpie to the front bumber and traced out the cutting lines.View attachment 3946View attachment 3947
Punched a hole in each corner with a drill to provide access for the jigsaw. First I covered the jigsaw plate to prevent scraping, then I just removed the entire plate to make it easier in tight spaces. Then I add some Loctite double-stick tape to the bottom and sides.
Once the double stick tape was in place, I placed the insert onto the car and drilled holes in the top; one on each end and one dead center to hold it in place.View attachment 3955
Before and After. Now she is going to breathe better.
All Ready for Paint!!!
All Ready for Paint!!!
looks real good and great post...
sdsubzero4
Spring Valley, CA
Nice modification.
Hopefully 30 degrees of cooling!!
MUSTANGO2GT
If u aint 1st, your last
nice job with the fox todd
Having the right tools and the template make the mod very simple. I say, "Go for it".
Paint completed...Ready for Mustangs by the Bay!!!! The sun was messing with the camera and causing glare. The paint job is AWESOME!!
sdsubzero4
Spring Valley, CA
Looks good, Todd