orange395w
OG MEMBER
Emilio dropped off some SS tail pipes that had been cutoff and he asked if I could put them on his car. The first order of business was to clean up the old ones. I had to cut them and then remove the pieces of pipe that were slip fit into the tail pipes.
Once those were out I had to cut off the old pieces of exhaust hanger and clean the old welds off. They came out pretty good.
Here are the pipes after being cleaned up. I did that with an eraser.
Here is a quick shot of the old driver's side pipe. Note the angle of the dangle.
Old tails were marked and cut.
Once they were cut off I had to cut the old hangers off, so I could reuse them on the new SS pipes.
Then it was time to weld them on.
Finished. I think they look good. Time for Emilio to get out the never dull and polish them up!
Once those were out I had to cut off the old pieces of exhaust hanger and clean the old welds off. They came out pretty good.
Here are the pipes after being cleaned up. I did that with an eraser.
Here is a quick shot of the old driver's side pipe. Note the angle of the dangle.
Old tails were marked and cut.
Once they were cut off I had to cut the old hangers off, so I could reuse them on the new SS pipes.
Then it was time to weld them on.
Finished. I think they look good. Time for Emilio to get out the never dull and polish them up!
. He should have you install a "complete" rear suspension while it's up in the air.
